Renovated Radios LLC II : Philco

Philco chassis bumper or spacer
(item ch22)

Dimensions: 1-1/16" diameter, 5/8" thick, 1/4" hole

Philco Chassis support
(item ch8)

Dimensions: base: 1" diameter, 3/8" tall; top: 1/2" diameter, 1/2" tall; 5/16" hole; 13/16" overall height

Philco 18 chassis bumper
(item ch20)

Dimensions: 5/8" diameter, 5/8" thick, 1/4" hole, and the groove is 1/8" from one end.

Philco chassis support
(item ch21)

Large Support Dimensions: 1-3/8" large diameter, 1-1/8" small diameter, 7/8"thick, 1/2" hole

Small Support Dimensions: 1-1/16" large diameter, 3/4" small diameter, 5/8" thick, 3/8" hole

Philco & Firestone dial bumper
(item ch24)

Dimensions: 1/2" diameter, 1/2 " thick

Philco screw sleeves
(item ch15)

Dimensions: 1/2" diameter, 7/16" thick, 3/16" hole.

Philco chassis supports
(set of 4)
(item ch25)

Philco sub-chassis supports (set of 3)
(item ch17)

Dimensions: 1-1/8"diameter, 7/8" smaller diameter, 5/16" total thickness, 3/16" hole.

Philco 46-480 dial/pushbutton Support
(item ch19)

Dimensions: 1/2" diameter, 5/16" thick, 1/16" offset groove, with a 1/4" hole, fits a 3/8" chassis hole.

Philco "Hippo" tuner grommet
(item t20)

Dimensions: 1/2" wide, 11/32" tall, 1/4" hole, fits a 5/16" chassis hole.

Philco 690/116 sub-chassis supports (set of 3)
(item ch18)

Dimensions: 1" diameter, 3/4" smaller diameter, 7/16" total thickness , 1/4" hole.

Philco 89 tuner support
(item t19)

Dimensions: 5/8” diameter, 13/64” thick, 7/32” hole

Philco chassis support 3/8"
(item ch32)

Dimensions: 7/8" diameter, 3/8" thick, 1/4" hole

Philco shadow meter mask
(item ch26)

Dimensions: 1-1/2" length, 5/8" width, 1/2 " height

Control Shaft Spacer for Philco 37-89
(item ch35)

Dimensions: 1-1/8" diameter, 1/4" thickness. 1/4" hole.

Philco tuner support
(item t03)

Dimensions: 5/8" larger diameter, fits into a 7/16" chassis hole, 1/4" thick, 7/32" hole

Philco 38-10 tuner support
(item t11)

Dimensions: 1" long, 5/8" deep, 1/4" thick

Philco Tuner Support
(item t04)

Dimensions: 5/8" diameter, 7/16" thick, 1/4" hole, top and bottom sections each 3/16", fits into a 7/16" chassis hole.

Philco "Hippo" tuner support
(item t01)

Dimensions: 1/2" diameter, 11/32" smaller diameter, 5/16" thick, 3/16" hole